MaxEye Series, MaxEye.ST Series

By detecting regularly occurring defects or defects occurring within a certain area, the MaxEyeSeries (or STSeries) can efficiently analyze their cause. You can use this system not only to avoid shipment of products with defects, but also to avoid the defects themselves.

MaxEye.X640

The MaxEye.X640 can be set to 4 times faster motion than conventional products.

Full Capture Unit

With the Full Capture Unit, you can try various detection criteria after saving the inspection results.

AccureX3

The AccureX3 measures the thickness of the coating of a sheet with soft X-Rays.

AccureX Jr.

Only by siding the AccureX Jr.’s table, AccureX Jr. can measure thickness within 1mm intervals.

MaxEye.X Series

With its high speed camera (8000 pixels/640MHz), the MaxEye Series can detect micro defects on high speed lines.

Full Capture Unit

By using the recorded data, the Full Capture Unit can simulate the detection of defects with various parameters (search criteria).

AccureX3

With the AccureX3, you can adjust the coating material supply from the measurement result.

MaxEyeX Series

With its high sensitivity and its wide dynamic range sensor, the MaxEyeX Series can detect low contrast light dirt.

Full Capture Unit

The Full Capture Unit allows you to check images captured by its line sensor camera and examine the parameters (search criteria) on repeat.

MaxEyeSeries

With the MaxEyeSeries, you can split the detected defects into categories and select to detect only high priority ones.

Plain surface inspection system

Yes. With the Plain Surface Inspection System, you can also check inspection data before slit by dividing it into slitter units. As an option, it is also possible to add a slitter support tool.

Full Capture Unit

With the Full Capture Unit, you can check single continuous images, even when large defects appear.

Full Capture Unit

With the Full Capture Unit, you can use the recorded data to try various functionalities, even when offline.